Kickmydog BM/MM/SV Hunter Profiles.

[kickmydog]

Something happens with Lynx Rush, until you manually pressed not continue with the rotation. and when it is available again, the rotation is stopped

When i use the V37 all works Fine

I'll look into this some more when I have some time. Thankfully no sane raiding hunter uses lynx rush.

[kickmydog]

I played with Marksman and it did beat BM in DPS by a considerable amount. I was surprised by how much, a good 20k higher most of the time. I do have a couple questions when doing SOO how do I set up spell interrupts? I am kinda new to PQR and did not find a write up on how to set up interrupts. Also I cannot seem to stop it from misdirecting.

thx

Check what your interupts are set to in PQR, this isn't something that is set by the profile but by PQR in general

[expunge]

Check what your interupts are set to in PQR, this isn't something that is set by the profile but by PQR in general

To be honest, the interrupts haven't worked in PQR for me for a long time. No matter if I enable them or not, on any class. Not sure why.

[2Deep]

How do I check that? BTW love the profile when I get more time with it I will provide more useful feedback.

[buttmule]

how can i make the engineer gloves to be nonstop cd since i got assurance?

[kickmydog]

how can i make the engineer gloves to be nonstop cd since i got assurance?

go to ability editor, find an ability in the profile that is used most often, and then put in ACTIONS, /use 10

[kickmydog]

How do I check that? BTW love the profile when I get more time with it I will provide more useful feedback.

Should be something like CTRL+C or something, I don't recall the default because I may have changed the my personal interrupt settings at some point in the past.

[kickmydog]

To be honest, the interrupts haven't worked in PQR for me for a long time. No matter if I enable them or not, on any class. Not sure why.

honestly I haven't had a problem with Xelper's default one, apart from changing the code so that it works for counter shot. I can't get it to work with silencing shot though.

[Centralx]

testing mm in lfr at 565+ ilvl, working quite nice.

[Kaylo]

how can i make the engineer gloves to be nonstop cd since i got assurance?

KickMyDog said the most simple way. Although if you want to make an ability for it:

if GetInventoryItemCooldown("player",10) == 0 then 
		UseInventoryItem(10)
	end

[Shtubba]

MM profile is working great for me. One small issue -- only affects simming for me at this point -- Glaive Toss will not cast when I'm targeting a Raider's Training Dummy using the Single and Multi MM Profiles. It seems to cast on all normal and elite mobs and the lvl90 dummy, but not the Raider one for some reason. I have yet to try it on a raid boss, so I don't know if there's a correlation there, but guessing you would have heard something by now if there was.

Thanks for all your hard work. I like infuriating our Arcane Mage by topping the charts...

[jackson27]

These profiles are always fantastic. I just wish it were easier to alter the keybinds. Rather than have to go in and change each trap ect. Unless I'm missing something?

[kickmydog]

MM profile is working great for me. One small issue -- only affects simming for me at this point -- Glaive Toss will not cast when I'm targeting a Raider's Training Dummy using the Single and Multi MM Profiles. It seems to cast on all normal and elite mobs and the lvl90 dummy, but not the Raider one for some reason. I have yet to try it on a raid boss, so I don't know if there's a correlation there, but guessing you would have heard something by now if there was.

Thanks for all your hard work. I like infuriating our Arcane Mage by topping the charts...

Glaive toss is supressed in the careful aim range, if the target dummy is in that range you won't get a glaive toss.

[kickmydog]

These profiles are always fantastic. I just wish it were easier to alter the keybinds. Rather than have to go in and change each trap ect. Unless I'm missing something?

No you are not.

[kickmydog]

KickMyDog said the most simple way. Although if you want to make an ability for it:

if GetInventoryItemCooldown("player",10) == 0 then 
		UseInventoryItem(10)
	end

Yeah that is the slightly harder way of doing it.