after a lot of messing around my my monitor resolution and in game resolution, ive got it working amazingly well
many thanks for sharing
after a lot of messing around my my monitor resolution and in game resolution, ive got it working amazingly well
many thanks for sharing
Having a problem on sarapin level 20. I go in and my mission starts like 10 seconds after its it and then i come back 3 minutes later to check if its still normal but its just not shooting anymore. Why?
Sarapin bugged as hell. Not working at all, about 25/75 at the end...
Hackhac, contributor && donator.
Got a working timer for Drexel for those with lower end machines
57500 - 31800
from 10 goes i got 6 complete , 2 fails by not killing enough ships and 2 fails from plain old blowing up
obviously a minor tweak may be needed but at least u know what direction to tweak the timers
hopefully this will help a few of you
Thanks again for the Bot![]()
Finally got my Sullust running
Something I did notice though was after 5ish hours of running the bot, it decides to stop barrel-rolling and stops using the anti-target special (3rd special on the bottom)
Hi, I have been trying to get this to work but haven't had any luck. I followed the instructions perfectly and the problem is the cursor wont match up to the space missions that it is trying to select. I have tried moving the window around here and there about 100 times and the farthest I have gotten is it clicks the right planet area and then cannot click the space mission, (about 1/2 inch away from it) So if I move the window to right, it wont even click the planet area to begin with and vice a versus,
Please help, this bot sounds great!
Hello,
I have been having issues in the midst of the very last mission < Republic: Kalee(Level 44) >
At this time I am using: Luckys_Spacebot_v3.31
Issues:
-Taking down the "Ace Mark VII Interceptors" -> (Bonus) 0/30
-The pixel detection seems to target the planet for the most part; causing failure of mission.
I am currently level 49, all thanks to your bot. Currently using full spaceship upgrades etc (If that helps, but shouldn't be the reason why it fails on the most part?)
Thanks,
Regards.
is your desktop (Not game resolution) set correctly and high enough to allow the game window to correct size?
is the game resolution set correctly?
1024X768
Lucky:
"Make Em" the bot 3for me is still targeting the red health bars for the shield generators on the Capital ship.
Is this intended Lucky?
So far from what i can see this bot is absolutely amazing but I have the same problem ive tried changeing desktop resolution and moveing the window around best i can get is 1/4-1/2 inch away from clicking the space mission in the bottom right corner ( my cursor is too high)
wondering if my desktop res or monitor size could be a issue im plpaying on a 27" wide screen 1920x1080 but i have tried every resolution i could and cant get farther than that im wondering what desktop res you guys are able to get it running at thanks in advance
Fixed the problem by switching to a older monitor Desktop res 1280x1024 bot runs flawlessley!!!!!!!!
I got mine to work fine, I was using a widescreen monitor too and that was the problem even after setting the resolution for both in-game / desktop
Here is what I did:
---> Radeon settings
--->Flat panel properties
---->Enable GPU scale
---->Use centered timings
Not sure for Nvidia users, but this made the screen into a square like a regular montior and everything worked great.
Can't get it to do makem, finished 7/14 for the objective, every time.
Can't seem to get this bot to top 30 runs. After getting 3 bars or so, then the bot gets "stuck" and won't run again. I have noticed a few times that it seems to spin the Point-of-view around, to where I am looking top down on my character. This is usually ok, but occasionally it gets skewed a different way. I am wondering if this is due to mouse drag or anti-bot code. I would guess that the bot continues to send its commands, not realizing the character is looking the wrong way. A couple times the bot continues to send out the crewskills, even though it was unable to do the space missions. The last couple times, the bot got stuck at the choose shard/server screen.
I wonder if there is a way to try to reset the P.O.V. every so often.