Mass Loot Boxes

[Strathrename]

If you click two open boxes at the same time (only tested w/ picked junkboxes in inventory) you will loot them both. I used a lag switch to check my entire inventory of heavy junkboxes at once, works nicely.

[Maisteri]

If you click two open boxes at the same time (only tested w/ picked junkboxes in inventory) you will loot them both. I used a lag switch to check my entire inventory of heavy junkboxes at once, works nicely.

Works with DE and Prospecting as well.

[Strathrename]

You have to cast them though, so how would that work?

[Maisteri]

You have to cast them though, so how would that work?

Click another item right when the cast ends and it won't loot the item you disenchanted/prospected

[Cecu]

Actually you can chain DE/Prospect/Mill, if you are precise in timing! You should cast it right before finishing the previous cast, and before opening the loot window.
If you cast too early, will get an error.
If you cast too late, it will fill the cast bar, loot the previous destroy meanwhile, and get error, when the cast is done.
If you got the timing right, you will chain cast, and loot on foreground every time.
Thats is dependant of your latency alot. In my experience, I done it with Milling every time, and with Prospect, Disenchant not always.

You could try it with any autoclick program to find the right timing for yourself.
For Milling in the 1000-1500ms range and for Prospecting 2000-2500ms

Enjoy!

[Wilbo007]

plz change font colour my eyes hurt sorry

[nerfmeplease]

Actually you can chain DE/Prospect/Mill, if you are precise in timing! You should cast it right before finishing the previous cast, and before opening the loot window.
If you cast too early, will get an error.
If you cast too late, it will fill the cast bar, loot the previous destroy meanwhile, and get error, when the cast is done.
If you got the timing right, you will chain cast, and loot on foreground every time.
Thats is dependant of your latency alot. In my experience, I done it with Milling every time, and with Prospect, Disenchant not always.

You could try it with any autoclick program to find the right timing for yourself.
For Milling in the 1000-1500ms range and for Prospecting 2000-2500ms

Enjoy!

I have my G15 macro set to 1.260 or something seconds per cast for this very reason, the looting (for me at that rate of casting) doesnt make it stutter on looting/recasting. its all about your latency and timing.

Good idea with the lag switch though

[rabber]

I might not understand this 100%, but is the only thing you gain with this the 0.5 sec it takes to autoloot?

[HeavyFrost]

I already figured this out by DE'ing my stuff, but how can this be usefull? it only deceases some time.